CONCRETE SUBSTITUTE
+7(495)989-40-46
Do you want to make installation works two times faster? Do you want to save some labor having been reduced your team by half and benefit from price reduction? HILST Professional makes it possible!
Price: 87 EURO / 10.0 liters.
* Because of HILST high penetrating capacity a hole diameter is 1.5 times less than concrete works require, and material consumption 2 times less (direct comparison shows 10 liters of HILST substitutes 400 kilos of dry concrete mixture or 0.25 m3 of concrete).
** We recommend using 8-10 liters bucket for mixing maximum 2 liters of each component (total volume will be 4 liters that is sufficient to fill up to 8 holes).
![]() Comparison of traditional concrete mixture and HILST Standard |
![]() Using HILST concrete substitute for fence posts' installation |
Наименование показателя | Значение |
Volume of compound | 10.0L (2 cans 5.0L each) |
Ready-made mixture volume after expansion is over | 140 L |
Quantity of holes* | up to 20 ea |
Recommended mixing time of A and B components** | 15-25 sec |
Start expansion time*** | 45 sec |
Finish expansion time*** | up to 3 min |
Reaching 80% of strength*** | up to 5 min |
Reaching 100% of strength*** | up to 3 hrs |
Compressive strength upon 10% deformation**** | 677 kP |
Water weight ratio, up to | 1,3% |
*Sample calculationFor 20 holes with following posts’ dimensions:
- 62mm x 55mm: hole diameter 100mm; depth 1000mm.
- 60mm x 60mm: hole diameter 100mm; depth 1000mm.
- 80mm x 80mm: hole diameter 100mm; depth 1000mm.
- 100mm x 100mm: hole diameter 150mm; depth 1000mm.
- diameter 76mm: hole diameter 100mm; depth 1000mm.
For 8 holes with following posts’ dimensions:
- 62mm x 55mm: hole diameter 150mm; depth 1000mm.
- 60mm x 60mm: hole diameter 150mm; depth 1000mm.
- 80mm x 80mm: hole diameter 150mm; depth 1000mm.
- 100mm x 100mm: hole diameter 200mm; depth 1000mm.
- 76mm diameter: hole diameter 150mm; depth 1000mm.
For 5 holes with following posts’ dimensions:
- 62mm x 55mm: hole diameter 200mm; depth 1000mm.
- 60mm x 60mm: hole diameter 200mm; depth 1000mm.
- 80mm x 80mm: hole diameter 200mm; depth 1000mm.
- 100mm x 100mm: hole diameter 200mm; depth 1000mm.
- 76mm diameter: hole diameter 200мм; depth 1000mm.
** Recommended components’ temperature when mixing is +150С to +280С. If ambient temperature at work site is below zero, it is necessary to keep components in warm place with air temperature above +200С.
*** Under condition the temperature of HILST as well as ambient temperature is +200С. If the temperature is higher the reaction rate increases and vice versa. Under the most unfavorable conditions reaching maximum strength takes no more than 24 hours.
**** Reference value for mixing 4 liters (drill mixer) for 15 sec at temperature of +200С.
Product code: 4620769390189